2nd choice - Pivoting Router Lift OFL3.0K - Red Edition

Demonstration model | Fully functional | Limited RED edition in KREG format | swivelling from -5° to 50° | for motors with Ø 43 clamping neck | height fine adjustment & magnetic reducing plates

Not available at the moment

709,49 €

638,54 €

incl. VAT / excl. shipping costs

Under-table extraction for the swivelling milling lift | Minimalist | Effective

Shipping within 24 hours (working days)

39,90 €

35,91 €

incl. VAT

Art.-Nr: HE-DS1

1 Products

Quality from Germany
Solid construction of high quality aluminium and steel.
Fine height adjustment to 1/10mm
Extreamle precise fine height adjustment, with exact scaling an effective spindle lock, conveniently operated via Allen screw.
Smooth-running columns
Enable a stepless and exact fine height adjustment.
Compatible to common router motors
The OFL3.0 is compatible with a wide range of commercially available motors with 43 mm Euro-neck. All models can be found below.
The magnetic reduction plates offer more choice and control in choosing the right hole size. Perfectly adapted to the size of the router cutter - especially for small workpieces,"snagging and getting stuck" on the edge of the hole eliminated!
Routing also without rip fence
2 drill holes for the fence pin allow you to free rout round workpieces without rip fence.
Absolutely flat
Easy levelling of the OFL3.0K by levelling screws in the insert plate. Optionally a frame for a permanent level adjustment can be purchased.
No drilling necessary
Mounting holes (countersunk) for quick installation are already pre-drilled.
Lasered scaling
Millimeter scaling on the surface for exact alignment of the rip fence.

Directly compatible and approved router motors:

AMB (Kress): 530 FM, 800 FME, 1050 FME
MAFELL: FM 800, FM 1000
SUHNER: UAC 30 RF, UAD 25 RF, UAK 30 RF, UAK 30 RF SPZ12
- If your motor is not listed, please check the tolerances of the clamping neck of your model as specified by the manufacturer or contact us.
MAFELL FM1650PV-LO not compatable