With the addition of 80mm and 96mm holes, alongside alignment pin threaded holes, our jig now facilitates seamless alignment against sheet material edges, streamlining the hole initiation process without relying on pre-existing holes.
Crafted to perfection, the new MK4 346 (32mm, 48mm, 64mm, 80mm, 96mm) offset hole jig empowers you to achieve precise results within minutes. Utilise a 30mm guide bush/copy ring and a 20mm router bit, adjust the jig to the desired position within existing holes, evenly tighten the quad bases, and plunge into action.
Made for MFT tables with 20mm holes spaced at 96mm centres.
Technical Data
For MFT tables with 20mm holes spaced at 96mm centres.
32mm, 48mm, 64mm, 80mm, 96mm spaced holes
Properties & Advantages
The 80mm and 96mm holes, alongside alignment pin threaded holes facilitate seamless alignment against sheet material edges, streamlining the hole initiation process without relying on pre-existing holes
Utilise a 30mm guide bush/copy ring and a 20mm router bit (Not included), adjust the jig to the desired position within existing holes, evenly tighten the quad bases, and plunge into action.
