for clamping and positioning guide rails FS, FS/2 and GRP/2
Using the FS-Rapid quick-action clamp, the guide rail can be fixed to the workpiece via clamping on the side. This is done with a single hand movement. Not only is it very quick, but it also enables the rail to be clamped on workpieces for which clamps cannot be used.
Properties & Advantages
The FS-RAPID/L quick-action clamp is specially developed for use with the SSU 200 and IS 330 sword saws thanks to the cutting angle adjustment to the left
May also be employed if no clamps can be used; for example, for thick bundles of insulating material
Time saving due to very quick fixing through just a single hand movement
No moving around the workpiece to release or tighten clamps
Soft rubber bearing points for workpiece protection and slip-resistance
Can be inserted into the clamp groove in all Festool guide rails
The clamping force of the clamping screws can be readjusted
for use of SSU 200, IS 330 with guide rail
for clamping and positioning with Festool guide rails
