Panel Raising Cutters

The panel raising cutter is used for flattening the wood, for example on furniture doors and kitchen fronts. Various Forms, radii and diameters are available. Which special dimensions you choose for the cutter is on the one hand a matter of taste and on the other hand is determined by the strength and dimensions of the Workpiece. If the routing cutter is guided on the ball bearing, classical or curved fillings can be routed.

Profile-Facing Cutter Z2

D: 41 mm | D2: 7 mm | C (NL): 12 mm | R: 12 mm | S: 8 mm

105,61 €

Facing Cutter HM Z2

D: 45 mm | D2: 11 mm | NL (C): 17 mm | A: 10° | GL (OL): 49,5 | S: 8

98,15 €

Panel Raising Ogee Cutter D: 50,8 mm

D 50,8 mm | NL 12,7 mm | R 9,52 mm | T 19 mm | S 8 mm | SL 32 mm

102,55 €

Panel raising cutters for hand and table routers

A distinction must be made between working with the hand router and with the bench router. In the current category, you will only find cutters that are suitable for the hand router. Panel raising cutters are usually supplied without ball bearings. A distinction must be made between the different forms of the cutter: Depending on the profile form, a distinction is made between double hollow - flattening cutter, carnis profile, oblique flattening and flattening in chamfer profile.

The quality of the carbide-tipped cutters meets professional requirements. Working and total length are different in each case, so you are sure to find the right flattening cutter for manual work for your workpiece here.