This 2-piece cutter set is the perfect addition for all metric tine cutting templates. It Trimming Router Cutteris equipped with a metric ball bearing, so that in combination with the ENT Tine milling template or other metric templates, stable finger and dovetail joints can be produced. Due to the cutting edge at the Trimming Router Cuttern, these can be used for Boring can be used.
Technical Data
ENT Trimming Router Cutter 12,7 x 25 mm
Diameter (A): 12,7 mm
width (B): 25 mm
Cutting: 2 + 1 (with drilling edge)
Shank (C): 8 mm
Shanklength (D): 32 mm
Total length (GL): 62 mm
Ball bearing (KL): 12.7 mm
ENT Tine cutter 12,7 x 19,05 mm E8° - Ball bearing 16 mm
Ball bearing (KL): 16 mm
Angle (E): 8
Diameter (D): 12,7 mm
Working length (NL): 19.05 mm
Cutting (Z): 2
Shank (S): 8 mm
Shanklength (SL): 38 mm
Properties & Advantages
Cutting in carbide (HW)
Cutter dimensions are optimally matched to the ENT tine template
Suitable for manual router and stationary router
All ball bearings can be replaced. Fastening Trimming Router Cutterwith a lock washer for the spring washer and with a locking ring for the tine cutter
With the additional ball bearing matching the flush milling cutter, finger tines with the same tine width can also be milled with the template
