Limited edition in RED | Unique and dust-free | With exact height fine adjustment & magn. reducing plates | for router motors with Ø 43mm clamping neck
If your motor is not listed, please check the tolerances of the clamping neck of your model as specified by the manufacturer or contact us.
MAFELL FM1650PV-LO not compatable
Properties & Advantages
Quality from Germany Solid construction of high quality aluminium and steel.
Fine height adjustment to 1/10mm Extreamle precise fine height adjustment, with exact scaling an effective spindle lock, conveniently operated via Allen screw.
Smooth-running columns Enable a stepless and exact fine height adjustment.
Fits in (almost) every router table Robust, anodised aluminium insert plate in the familiar outline dimensions of 306 x 229 mm and thus interchangeable with our previous insert plates (e.g. FO-RTS2 or T-RTI-PLATE).
Compatible to common router motors The OFL3.0 is compatible with a wide range of commercially available motors with 43 mm Euro-neck. All models can be found below.
The magnetic reduction plates offer more choice and control in choosing the right hole size. Perfectly adapted to the size of the router cutter - especially for small workpieces,"snagging and getting stuck" on the edge of the hole eliminated!
Routing also without rip fence 2 drill holes for the fence pin allow you to free rout round workpieces without rip fence.
Absolutely flat Easy levelling of the OFL3.0 by levelling screws in the insert plate. Optionally a frame for a permanent level adjustment can be purchased.
No drilling necessary Mounting holes (countersunk) for quick installation are already pre-drilled.
Lasered scaling Millimeter scaling on the surface for exact alignment of the rip fence.
