Precision fence for the Vario-Bench and other multifunction tables.
Extra long workpiece stop for stable support and perfect alignment of workpieces relative to the guide rail.
The flattened side allows workpieces to be supported even below the guide rail (from 8 mm material thickness) - thus particularly helpful for smaller workpieces.
to be attached to the sauter magnetic bench dogs | Compatable with Festool, Makita & Triton guide rails
Shipping within 24 hours (working days)
35,85 €
incl. VAT
Art.-Nr: SA-VB-MAG-KIT
7 Products
Technical Data
Size: 900 x 40 x 11.8 / 7.8 mm
Material: anodised aluminium
Properties & Advantages
Hole pattern compatible with the 0° to 4° holes of the large Vario-Bench plate (1200 x 800 mm).
Compatible with all Ø 20 mm hole pattern / multifunction tables with 100 mm or 96 mm (e.g. Festool) hole spacing in 0°, 45° and 90° angles
The continuous stop is an advantage, especially for shorter workpieces that cannot be attached to two bench dogs.
Due to the elongated holes, the stop also fits with non-exact hole spacing of 96 mm or 100 mm
Flattened at one end to easily process thin material up to 8 mm
In combination with the stops (SA-VB-RIDER), the repeatable machining of several workpieces (e.g. formatting to the same size) is made much easier
Perfectly matched to the diameters of the Vario-Bench bench dogs
The fence can also be used for precise alignment of tools at squares to a workpiece edge, e.g. for flat dowel milling in the surface of the workpiece (for workpieces up to 60 cm wide)
Compatible with the low-profile bench dogs (SA-VB-BDOG-LOW) - the stop rider then does not touch the workpiece
