-10%

Epoxy resin starter set 1.4 kg

Food-safe casting resin for layer thicknesses of up to 4 cm | Mixing cup incl. outer container and lid | Silicone brush | Stirring rods

Delivery in 1-2 business days

€65.00

% €72.39 (10.21% saved)

Brand: S U. K HOCK GMBH

Item no.: SET-EPOXY-STARTER

Weight: 4.39 kg

Scope of delivery

Manufacturer

Manufacturer:
S u. K Hock GmbH
Straßfeld 12 94209 Regen Germany
[email protected]

EU representative:
S u. K Hock GmbH
Straßfeld 12 94209 Regen Germany
[email protected]
https://woodresin.de/

Downloads

Minimum pouring height
1 mm
Maximum pouring height
4 cm
Mixing ratio resin
hardener: 100 : 45
Processing temperature
20 °C
Processing time at 20 °C
60 - 90 min
Tack-free / next layer possible at 20 °C
10 hrs
Demouldable after
12 hours
Final strength
7 days (After reaching final strength: intermediate sanding necessary for casting the next layer!)
Heat resistant up to
60 °C
Content
1.4 kg
Storage
dry, at 10-25 °C, without exposure to sunlight
Storage stability
approx. 6 - 9 months in sealed original container
Observe the manufacturer's processing instructions.

The resin and hardener set comes in the correct mixing ratio of 100:40 (it is best to weigh the resin and hardener with the scales).
Mixing cups, stirring rods and brushes are included in the starter set.
The epoxy resin is UV-resistant and is suitable, for example, for making scantlings for woodturning or snack and serving boards.
Suitable for colouring with a maximum of 10% colour paste, pigment or concentrate.
Temperature resistant up to 70 °C.
The silicone brush is reusable.
Important: Potting volume and layer thickness are interdependent. The thicker the layer, the smaller the mixing volume must be!
An ambient temperature above 20 °C can cause the mixture to boil and lead to boiling bubbles, stress cracks and discolouration!
For scantlings with a layer thickness of 1 mm - 4 cm, the maximum casting volume is 250 g.
For cutting boards with a layer thickness of 1 mm - 2.8 cm, the maximum casting volume is 2.8 kg for a layer thickness of 2.8 cm and 10 kg for a layer thickness of 1 cm.
Processing instructions: The objects to be embedded must be clean and free of dust, oil and grease. The moisture content of the wood must be below 13%.